7
■
■
■
■
■
■
■
■
■
■
ASSE
I
MBLY
This walk-behind blower was partially assembled at the factory. To assemb
l
e your machine follow the below instructions.
FRAME
Insert the end of the front swivel caster tube into the opening of
the frame tube, and a
l
ign the holes.
Attach the tubes to the engine deck with M8x40 bolt, arc washer,
spring washer and lock nut in four places. Tighten securely using
two 13mm wrenches. (See
Figure 2)
Figure2
M8x40
WHEELS
Install one spacer onto the wheel axle.
Slide the wheel onto the axle.
x4
ml
Secure the wheel in place with a flat washer and a cotter pin on
the outside. Bend and spread the cotter pin prongs in opposite
directions.
Repeat these steps to install the 2nd wheel. (See
Figure
3)
9
I
Assembly
Figure3
x2
-----
SWIVEL CASTER
Install one bushing onto the underside (bottom side) of the swivel
caster bracket opening, with the smaller end of the bushing facing
up.
Install the caster by pushing the caster tube up through the
bracket opening.
Install the 2nd bushing onto the shaft and insert it into the top of
the caster bracket opening, with the smaller end of the bushing
facing down.
Secure the swivel caster to the caster tube using a flat washer,
spring washer and acorn nut. Tighten securely using a 16mm
wrench. (See
Figure
4)
Figure4
