Nuts M8
(x2)
2
Jam Nut
Lock Nut
3
1
Adjustment Nut
4
Jam Nut
Adjustment Nut
Jam Nut
10
mm
13
mm
18
mm
19
mm
12
mm
7
mm
30
mm
8
mm
10
mm
13
mm
18
mm
19
mm
12
mm
7
mm
30
mm
8
mm
REPLACING DRIVE BELT
Unlock and tilt the hopper to gain access to the belt
covers.
Remove the three 8mm bolts and nuts on the
secondary belt cover.
Remove the two 8mm nuts on the bottom of the main
belt cover. Also, remove the 8mm bolt on the top right
side of the belt cover. (See
illustration below
)
Remove both belt covers.
now remove the belt off the pulleys by rolling the belt
off the motor pulley in a counter clockwise motion.
Remove the belt off the transmission pulley and
remove belt from the machine.
Assemble the new belt and reattach the covers.
10
mm
13
mm
18
mm
19
mm
12
mm
7
mm
30
mm
8
mm
Loosen the jam nut by turning it counter clockwise
with 12mm wrench while holding the lock nut in place
with 10mm wrench. (
See Figure 8b, Illustration 2
)
While holding the lock nut in place with a 10mm
wrench, tighten (or loosen) the cable by turning the
cable adjustment nut clockwise (or counter clockwise)
with a 10mm wrench until you have reached your
desired tightness. (
See Figure 8b, Illustration 3
)
Once you have reached your desired cable tightness,
tighten the jam nut by turning it clockwise until it is
tight against the lock nut. (See
Figure 8b, Illustration 4
)
3.
2.
1.
If the above adjustment does not create enough cable
tension, adjust the cable tension near the handle by
following the below steps.
Figure 8b
Figure 9a
Figure 9b
10
mm
14
mm
16
mm
19
mm
12
mm
7
mm
30
mm
8
mm
18
Power Wheelbarrow
»
Operator’s Manual
YD4103PM02 - 1706
Maintenance
|
