6
SEALANT:
• All surfaces to be clean, dry, dust and grease free before application with
temperatures above 5°C (41°F), no warmer than 35°C (95°F).
•
Cut tip off sealant tube, attach supplied nozzle and use a caulking gun to apply
small beads. See below images.
• Apply sealant in small beads and smooth as required.
•
To smooth sealant into the joint use a glove covered finger, putty knife, etc.
Smooth sealant to create a continuous water-tight seal.
• Clean excess with a cloth or paper towel before it skins over.
• An initial bond will set in approximately 20 minutes and fully set in 24 hours.
WARNING:
• CAUSES SERIOUS EYE AND SKIN IRRITATION. Always wear safety glasses
and rubber gloves when using product.
• KEEP OUT OF REACH OF CHILDREN.
• Prolonged or repeated exposure MAY CAUSE ORGAN DAMAGE. Provide
ample ventilation.
FIRST AID:
• If ingested, DO NOT INDUCE VOMITING. Seek immediate medical attention.
•
Eye contact: immediately flush eyes with water for at least 15 minutes. Remove
contact lenses if present.
• Skin contact; wash thoroughly with soap and water. If eye/skin irritation persists
or respiratory symptoms occur or develop, seek medical attention.
Use of this product can expose you to chemicals including Methanol, which is known
to the State of California to cause birth defects and other reproductive harm. For
more information, go to www.P65Warnings.ca.gov.
Dispose of contents and container in accordance with local regulations.
Sealant Application Tips, Warning and First Aid Information
Step 1: Cut off
tip of tube
Step 2: Attached
supplied nozzle
Step 3: Put tube
in caulking gun
Содержание YM12842
Страница 100: ...100 support yardistrystructures com...
Страница 101: ...101 support yardistrystructures com NOTES...
