Yard Works 60-3800-4, Инструкция по эксплуатации

Страница: 15 / 20

Troubleshooting
Use this troubleshooting information to remedy problems that may occur during
the operation of the log splitter.
Logs will not split
The problem may be with the log or with the machine:
• Make sure the log is properly positioned on the worktable. See
Select/prepare a log for splitting in the Operation section.
• The size or hardness of the log may exceed the capacity of the splitter.
Reduce the log size before placing it on the splitter.
• Splitting wedge cutting edge is blunt. See Sharpen the splitting wedge in the
Maintenance section.
• The bleed screw was not loosened and air is trapped in the hydraulic tank.
Loosen the bleed screw one or two turns.
• The hydraulic fluid is low and may need to be replenished. See
Check the
hydraulic fluid level in the Maintenance section.
• The maximum pressure limiting adjustment setting has changed. Contact the
dealer.
Hydraulic fluid leaks
• The bleed screw may not have been tightened before transporting the splitter.
Tighten the bleed screw.
• The bleed screw may not have been loosened before operation and air is
trapped in the hydraulic system. Loosen the bleed screw one or two turns.
• The fluid drain bolt may be loose. Use the hex wrench to tighten the bolt.
• The hydraulic control valve assembly and/or seals may be worn. Contact the
dealer.
Push rod movement is jerky, makes unfamiliar noise or vibration
• The hydraulic fluid level may be low. Check the fluid level and refill if needed.
See Check the hydraulic fluid level in the Maintenance section.
• There may be air in the hydraulic system. Loosen the bleed screw one or two
rotations.
Printed in China
YW Log Split 60-3800-4 E 1/3/04 2:20 PM Page 16
15