Yard-Man 435, Руководство оператора, Страница: 8 / 20

8
• Insert post of cable ties that are on lower handle
into the holes provided on the lower handle. The
holes may be on the inside or outside. Pull cable
ties tight and cut off the extra. See Figure 5 below.
Figure 5
Attaching Starter Rope
The rope guide is already attached to the right side of
the lower handle of your mower. See Figure 6 .
• With the spark plug wire disconnected and
grounded, hold the blade control handle against the
upper handle, and pull the starter rope up to the
rope guide. See Figure 6.
• Slip the rope through the rope guide as shown
below. Tighten the wing nut holding the rope guide
to the lower handle.
Figure 6
Grass Catcher Assembly
NOTE: Make certain the grass bag is turned right side
out before assembling (warning label will be on the
outside).
Parts for Soft Grass Bag
1. Front Frame
2. Rear Frame
3. Bag
Assembling Soft Grass Bag
• Join the rear frame and front frame assembly as
shown in Figure 7 A.
• Place the bag over the frame (black plastic side is
the bottom of bag). Slip the openings in the side of
the plastic channels on the bag over the hooks on
the grass catcher frame.
• Secure bag to frame by working the plastic
channels on bag over frame as shown in Figure 7 B.
All of the plastic channels except the center top of
the bag attach from the outside of bag. The center
top of the bag attaches from inside the bag.
Figure 7
Attaching Grass Catcher
• If your mower is equipped with a mulching plug, and
it is in place on the mower, lift the rear discharge
door and remove the rear mulching plug from the
mower. See Figure 8 .
Figure 8
NOTE: Make sure that the cable is routed to the outside
of the handle when attaching the grass catcher.
Cable Tie
Post on
Cable Tie
Slip rope into
rope guide
Wing Nut
Rope
Guide
Front
Frame
Assembly
Rear
Frame
Bag
Hook
Plastic
Channels
A
B
Frame
Rear
Mulching
Plug