24
TIRES
Maximum tire pressure under any circumstances is 30
p.s.i. Equal tire pressure should be maintained on all
tires. Check tire sidewalls for proper inflation.
When installing a tire to the rim, be certain rim is clean
and free of rust. Lubricate both the tire and rim
generously. Never inflate to over 30 p.s.i. to seat beads.
WARNING: Excessive pressure (over 30
p.s.i.) when seating beads may cause tire/
rim assembly to burst with force sufficient
to cause serious injury.
FUEL FILTER
Your unit is equipped with a replaceable in-line fuel
filter. Replace filter whenever contamination or
discoloration is noticed. Order replacement filter
through your authorized engine service dealer.
BELT REPLACEMENT
Deck Belt
•
Remove the deck by following instructions on
pages 11 thru 13 in reverse order.
Figure 28
•
Remove the left hand pulley cover by unhooking
the spring and removing five self-tapping screws.
See Figure 28.
•
Remove the first drive belt.
•
Remove the right hand pulley cover by removing
three self-tapping screws.
•
Pivot the spring-loaded idler, and lift belt off.
•
Remove the belt from around the three deck
pulleys.
•
Reassemble new belts in reverse order.
Front Drive Belt
•
Depress the clutch pedal and set parking brake.
•
Remove the deck from the tractor.
Figure 29
•
Raise and block the front wheels of the tractor so
you can work under it.
•
Remove the four self-tapping screws which hold
the belt keeper assembly to the frame at the engine
pulley. Push the belt keeper assembly forward, out
of the way. See Figure 29.
•
Remove the two pins which act as belt keepers by
the variable speed pulley. See Figure 30.
•
Roll the belt off the variable speed pulley, then
remove from the engine pulley.
•
Reassemble the new belt, following instructions in
reverse order.
Rear Drive Belt
•
First remove the front drive belt as instructed in the
previous section.
•
Disconnect the spring which secures the idler
pulley to the frame.
•
Remove the transmission cover by unscrewing the
two knobs, and removing two truss machine
screws.
•
Roll the belt over the top of the transmission pulley.
Remove belt from the variable speed pulley.
•
Reassemble the new belt, following instructions in
reverse order.
Deck Stabilizer
Diagonal
Brace
Right Hand
Pulley Cover
Left Hand
Pulley Cover
Belt
Guard
Idler
Self-Tapping
Screws
Belt Keeper
Assembly
Self-Tapping
Screws
Engine
Pulley
