![background image](http://html1.mh-extra.com/html/yard-machines/614e/614e_operators-manual_905996014.webp)
14
TO ENGAGE DRIVE/AUGER
1.
With the engine running near top speed, move
shift lever into one of the FORWARD or
REVERSE positions. Select a speed
appropriate for the snow conditions that exist.
Use the slower speeds until you are familiar
with the operation of the snow thrower.
2.
Squeeze the left hand auger drive clutch to
engage auger.
3.
While the left hand auger drive clutch is
engaged, engage the right hand traction drive
clutch.
NOTE:
NEVER move shift lever without first
releasing the drive clutch.
TIRE CHAINS
(OPTIONAL)
:
Use tire chains when extra traction is necessary.
OPERATING TIPS
NOTE:
Allow the engine to warm up for a few
minutes as the engine will not develop full power
until it reaches operating temperature.
WARNING: Temperature of muffler and
surrounding areas may exceed 150
o
F.
Avoid these areas.
• For most efficient snow removal, remove
snow immediately after it falls.
• Discharge snow downwind whenever
possible. Slightly overlap each previous
swath.
• Set the skid shoes 1/4" below the scraper bar
for normal usage. The skid shoes may be
adjusted upward for hard-packed snow.
Adjust downward when using on gravel or
crushed rock.
• Be certain to follow the precautions listed
under ‘‘To Stop Engine’’ in previous column
to prevent possible freeze-up.
• Clean the snow thrower thoroughly after each
use.
SECTION 8: ADJUSTMENTS
WARNING:
Never attempt to clean
chute or make any adjustments while
engine is running.
ADJUSTING CHUTE
You can control the distance that snow is thrown by
adjusting the angle of the chute assembly. The
sharper the angle, the shorter the distance snow is
thrown.
1.
To adjust the chute, loosen the hand knob. See
Figure 25.
2.
Pivot the top of the chute assembly to the
position desired.
Figure 25
ADJUSTING SKID SHOE
The space between the shave plate and the ground
can be adjusted by adjusting the skid shoe. Slide
the skid shoe upwards and lower the housing to
remove snow close to the ground. Slide skid shoe
downwards and raise the housing to remove snow
from uneven ground like gravel. For more details,
refer to page 11.
ADJUSTING TRACTION DRIVE CLUTCH
Refer to the Final Adjustments section on page 10
for instructions to adjust the traction drive clutch. If
you are not sure whether you have been able to
adjust the traction drive clutch properly, check as
follows.
1.
Drain the gasoline from the snow thrower or put
a plastic film under the gas cap if the snow
thrower has already been operated. Tip the
snow thrower forward onto the auger housing.
2.
Remove the frame cover underneath the snow
thrower by removing the six self-tapping screws.
3.
With the traction drive clutch released, check if
there is clearance between the friction wheel
and the drive plate in all positions of the shift
lever. For correct adjustment there has to be
enough clearance.
4.
With the traction drive clutch engaged, check if
the friction wheel is contacting the drive plate.
See Figure 26. For correct adjustment, these
two must contact.
Hand
Knob
Содержание 614E
Страница 20: ...20 SECTION 13 ILLUSTRATED PARTS HOUSING ASSEMBLY ...
Страница 22: ...22 HANDLE ASSEMBLY ...
Страница 24: ...24 FRAME ASSEMBLY ...