10
8.Connect Spray Wand and Quick-Connect Nozzles
9.Charging the battery
10. Install the battery
This 20V Li-Ion battery pack is equipped with a power indicator
which is used to show the battery pack’s remaining charge.
Press the power indicator button to check battery charge as
Open the battery tank cover, insert battery pack into the tank,
make sure it is locked in position, and then close the cover.
-When the battery pack is well installed, the green breathing
light on the remote control button will be illuminated and will begin
to flash at a rate of once per second.
below.
1) Attach other end of high pressure hose to base of spray
gun. Tighten by hand.
2) Attach the spray wand into spray gun. Tighten by hand.
3) Turn OFF the water and release trigger. Point the spray
1. Connect the charger to a power supply. The red LED light on
the charger will be on.
2. To insert the battery pack into the charger, align the grooves
on the battery pack with the raised ribs in the opening of the
charger.
3. Once the battery pack is correctly located in the charger, the
green LED light of the charger will flash continuously during
normal charging.
4. When charging is complete, the green LED lights of the
charger will be on.
gun at a safety direction and make sure trigger is locked
and can’t be squeezed.
4) Choose the quick-connect nozzle you want to use, pull
back on collar of spray wand , insert the nozzle and
release collar. Tug on the nozzle to make sure it is
securely in place. More information please see “How to
Use Quick-Connect Nozzles” section.
0°
15°
40°
Soap
CHECK-LIST BEFORE STARTING ENGINE
Review the assembly to ensure you have performed all of
the following:
• Be sure to read "Safety Rules" and "Operation" sections
before using the pressure washer.
• Make sure handle is in place and secure.
• Check that oil has been added to proper level in engine
crankcase.
• Add proper gasoline to fuel tank.
• Check for properly tightened hose connections (high
pressure and water supply) and for tight connections
and that there are no kinks, cuts, or damage to the high
pressure hose.
• Provide proper water supply (not to exceed 100°F).
• If starting pressure washer after storage, see "Storage"
section below.
- The battery pack is supplied partially charged. To ensure
the best performance, charge the battery completely before
first use.
- Make sure the main voltage is the same as rating label
which is located on the charger.
- Remove the battery pack from the charger after it has been
fully charged.
NOTICE:
NOTICE:
