22
Fault/malfunction
cause
Remedy
Pressure washers does not
work
No electrical voltage at the
device
Check the fuse, power cord,
power plug and power source
and have them replaced by
qualified personnel if necessary
On/off switch set to "0"
On/off switch set to "I"
Cross section of the extension
cord no large enough and/or the
extension cord is too long
Use extension cord with lager
cross sections and/or use
shorter extension cords
Extension cord damaged
try without extension cord
The protector on the PCB has
activated
Switch off the Pressure washer
and pull the plug out from the
power source, then restart the
Pressure washer
The mains voltage is lower than
that specified
Contact the power supply
company if necessary
The pump is frozen
Check and thaw if necessary
Pressure too low, but steady
Wrong spray tips was selected
Change to right spray nozzles
Hight-pressure hose are
damaged or leaks in the
connection
Change the hight-pressure
hose or hand-tighten the screw
connection
Leaks in the Pressure washer
Leaks from the pump or internal
connections
Consult customer service
Hose connections loose
Hand-tighten the water intake
adapter and the high-pressure
hose screw connection
Irregular operating pressure
Air intake in the water inlet
Check the supply hose and
hose connection and replace if
necessary
The water filter is clogged
Clean the water filter
Water supply hoses squeezed
Straighten out kinked water
supply hoses
Inadequate water supply
Check the water supply
The high-pressure washer
operates intermittently
Power cord is damaged
Consult customer service
Internal loose electrical
connection
Consult customer service
On/Off switch defective
Consult customer service
Y 2200BL indd 22
15-4-29 ��6 32
