Yard force LB G18W, Оригинальное руководство пользователя

Страница: 12 / 15

22 23
DESCRIPTION OF PRODUCT
Parts description (Fig. A)
1. Speed/Cruiser lock lever
2. Lower Tube
3. Flat nozzle
4. Air inlet
5. Trigger Switch
6. Control panel
7. Battery pack release button
8. Battery pack
Delivery contents (Fig. B)
Carefully unpack the appliance and check that it is complete. Dispose of the packaging
material correctly.
a. 40V cordless blower
b. Lower round tube
c. Lower flat nozzle
d. Manual
WARNING: If any parts are damaged or missing, do not operate this tool until these
parts are replaced. Failure to heed this warning could result in serious personal
injury.
NOTE: Always recycle the packaging in accordance with local recycling guidelines.
ASSEMBLY
Assembling the lower tube to upper tube
WARNING: Before performing any assembly. Always ensure that the battery pack has been
removed.
1. Select the tube nozzle type – round or flat
-
Round nozzle for general blowing.
- Flat nozzle for concentrated blowing
2. Aligning the slot on the lower tube with raised post on the upper tube. (Fig. C)
3. Push them against each other.
4. Twist the lower tube clockwise. (Fig. D)
5. Make sure that the nozzle is securely fitted. (Fig. E)
OPERATION
To insert the battery pack (Fig. F)
1. Align the groove on the battery pack with the corresponding ribs in the receptacle of the
device.
2. Insert the battery pack with moderate force until it locks in to place.
WARNING: Only use Yard Force 40V original battery pack!
To remove the battery pack from the tool (Fig. G)
1. Press once release to transport position.
2. Press again full releases the battery
3. Remove the battery pack from the tool.
Check before starting!
DANGER! Risk of injury! The device must only be put into operation if no faults are found. If
any part of the device is defective, it must be replaced before the next use.
Check the safety equipment and the safe condition of the device.
– Check all parts to make sure they fit tightly.
– Check whether there are visible defects: broken parts, cracks, etc.
To Start (Fig. H)
1. Depress the trigger and the blower will begin to run.
2. To lock the blower on, move the speed /crusier lock lever down to fix required speed.
The blower runs at higher speeds as the lever is moved further back. (Fig. I)
3. The speed /crusier lock lever lock can also be pulled back to start the blower without
needing to first depress the air-speed trigger.