Yard force GR40, Оригинальное руководство пользователя

Страница: 41 / 45

16 17
Charging the battery pack
As shown in Fig. 6
NOTE: The battery pack will be fully charged after 1H. Remove it from the
charger after it has been fully charged.
NOTE: This battery pack has been shipped in a low charge condition. It should
be fully charged before first use.
NOTE: Make sure the main voltage is the same as rating label which located on
the adaptor.
1. Plug the charger into an appropriate power supply. When connected, a green LED
light will flash.
2. To insert the battery pack into the charger, align the battery pack with the correspond-
ing receptacle on the charger, push the battery pack downward until it has been
locked in place.
3. Battery pack fully charges in 90mins, when charged a green LED light will show.
ASSEMBLY
Inserting the battery pack
WARNING!
Always release the On/Off switch before insert in or removal of the
battery pack. Remove the battery pack. Depress the button (A) on end of the
battery pack, and then remove the pack from the tool.
Install the battery pack. Align the ribs on both side of the battery pack with the slots in
the housing and slip it into place. Always insert it all the way until it locks in place with a
click sound. If not, it may accidentally fall out of the tool, causing injury to you or someone
around you. To release the battery from the product, push the button (A) on the battery
pack and pull away from the product.
Fig. 3
ASSEMBLY
Take off the blade sheath
Slide the blade sheath off before you start the machine.
Assemble the front handle
Attach the front handle to the block on the lower handle, and insert the bolt. Tighten the
knob to the bolt.
Fig. 4
Fig. 5
Fig. 6
A