![background image](http://html1.mh-extra.com/html/yard-force/ew-u15/ew-u15_instruction-manual_905841018.webp)
18
OPERATION
WARNING!
Before switching on the pressure washer, make sure that the pressure
washer is completely assembled and all the hoses are properly connected.
WARNING!
Make sure the pressure washer stands on flat ground in a secure and
stable position.
WARNING!
Hold the spray gun and the lance with both hands when using.
Be aware of the recoil.
WARNING!
Always wear hearing protection, safety glasses and protective footwear
when operating the pressure washer.
WARNING!
To prevent an accidental spraying operation, keep the trigger lock
engaged when not actually spraying, moving the pressure washer or adjusting the
lance.
CAUTION!
Never operate the pressure washer without water as dry running may
damage the pump. Use a water filter if the water is contaminated.
NOTE:
Before switching ON the pressure washer, prime the pump and high pressure hose
first by squeezing the gun trigger for around 5 seconds with the water supply turned on.
PRIMING (FIG. 12)
- Check that the water supply is turned on.
- Squeeze the gun trigger for 5 seconds or until water squirts from the end of the lance.
This is required to prime the pressure washers pump and the high pressure hose before
starting the pressure washer.
DETERGENT (FIG. 13)
CAUTION!
Use only detergents designed for use in pressure washers only.
If you would like to use detergent for the job at hand.
- Remove detergent bottle from the rear of the pressure washer.
- Fill detergent bottle with a good quality pressure washer detergent.
NOTE:
Detergent can only be dispensed with the adjustable lance that is set to low pressure
mode. See LANCE OPERATION