8
9
To obtain the best life from the battery
1. Never allow the battery to completely discharge before recharging. The battery pack
should be placed on the charger whenever the battery pack is noticeably running down
or the tool no longer performs a task it previously performed.
2. Avoid conducting short charges. Make sure that the battery is fully charged each time by
allowing the charger to complete its full charging cycle.
3. Avoid allowing loose items like screws or nails etc. to be stored with battery packs as
these or similar items can short battery packs and cause a fire or explosion
4. Always unplug the charger when not in use and store in a dry and secure place.
5. Avoid charging or storing your battery in temperatures below 5°C and above 45°C.
6. After use, allow the battery to pack to cool down for approximately 30 minutes before
attempting to recharge.
Maintenance and Cleaning
Occasionally clean the battery using a soft, clean and dry brush.
Transport
The contained lithium-ion battery is subject to the Dangerous Goods Legislation requirements
and is suitable for ground transportation by the user without further conditions.
When being transported by third parties (e.g.: air transport or forwarding agency), special
require- ments on packaging and labelling must be observed. For preparation of the item
being shipped, consulting an expert for hazardous material is absolutely re- quired.
Dispatch batteries only when the housing is undamaged. Tape or mask off open contacts and
pack up the battery in such a manner that it cannot move around in the packaging.
Please also observe possible additional national regulations.
Disposal
The machine, accessories and packaging should be sorted for environmental-friendly
recycling.
Do not dispose of power tools and batteries/ rechargeable batteries into household waste!
MAINTENANCE AND STORAGE
CE DECLARATION
To the provisions of Council Directives
We
MEROTEC GmbH
Otto-Brenner-Str. 8
47877 Willich, Germany
Declare that the product:
Machine Description: 20V Battery pack
AL C20E/ AL C20F
B0P-SP08-20ZB
Function: Power bank
Complies with the essential health and safety requirements of the following directives:
Electromagnetic Compatibility Directive 2014/30/EU
EC Directive 2011/65/EU and its amendment Directive (EU) 2015/863 (RoHS)
Standards and technical specification referred to :
EN 55011:2016+A1:2017+A11:2020
EN IEC 61000-3-2:2019
EN IEC 61000-3-3:2013+A1:2019
EN 55014-2:2015
EN 50581: 2012 EN62233: 2008
Authorized Signatory
Date:
24.03.2021
Signature:________________________
Place:
Willich
Name:
Roland Menken
General Manager
MEROTEC GmbH
Otto-Brenner-Str. 8
47877 Willich, Germany
