Yanmar 6LY3 series, Руководство по обслуживанию

Страница: 91 / 390

ENGINE Inspecting the Cylinder Block and Components
12/05
6LY3 Service Manual
5-25
© 2007 Yanmar Marine International
Measuring Cylinder Bores for
Out-of-Round:
Use a Dial Bore Gauge to measure the cylinder
bore diameters. Measure the cylinder bore twice at
right angles at positions 4 and 5 as shown in
Figure 5-13
.
Record the following measurements:
1. Two measurements at position 1 at the top of
the cylinder bore.
2. Two measurements at position 2 in the middle
of the cylinder bore.
3. Two measurements at position 3 at the bottom
of the piston ring travel in the cylinder bore.
This produces six different measurement values.
Calculate the average value of all the
measurements for each cylinder bore and compare
with the wear limits.
See Measuring Cylinder Bore
Diameters on page 5-25
.
Measuring Cylinder Bore Diameters
Measure the cylinder bore diameters and compare
the values with the wear limits stated below.
Cylinder Wear Limits
Item Standard Limit
Cylinder Bore
Diameter
105.900-105.930 mm
(4.169-4.170 in.)
105.950 mm
(4.171 in.)
Cylinder Roundness
0.03 mm (0.001 in.)
or less
—
Cylindricity
0.02 mm (0.0007 in.)
or less
—