Yanmar 3TNV82A-B, Руководство по обслуживанию

Страница: 205 / 394

ENGINE
TNV DI Service Manual 6-73
Crankshaft and Camshaft Components
9. Remove the fuel injection pump from the gear
case / front plate only if it must be sent out for
repair, or will interfere with other procedures
such as “hot tank” cleaning. If the fuel injection
pump does not need to be repaired, leaving it
mounted to the timing gear case or plate will
eliminate the need to re-time it during
reassembly. See Fuel Injection Pump on
page 7-19.
10. Remove the starter motor. See Removal of
Starter Motor on page 11-10.
Disassembly of Camshaft and Timing
Components
Discard all gaskets, O-rings and seals. Use new
gaskets, O-rings and seals on reassembly of the
camshaft and timing components.
Removal of Timing Gear Case Cover
1. Remove the bolt and washer retaining the
crankshaft pulley.
IMPORTANT
Use care not to damage the threads in the
end of the crankshaft when removing the
crankshaft pulley.
2. Remove the crankshaft pulley using a gear
puller.
3. Remove the bolts that retain the gear case
cover to the cylinder block and oil pan.
4. Remove the gear case cover (Figure 6-88, (1)).
Figure 6-88
Checking Timing Gear Backlash
Prior to removing the timing gears, measure the
gear backlash and determine the gear wear.
Check the backlash between each pair of mating
gears (Figure 6-89). If not within specification,
replace both mating gears. See Timing Gear
Backlash on page 6-13 for service limits.
Note: Do not allow the gear being checked to
move axially as excess end play could
cause a false reading.
0001641A
(1)
TNV_DI_SM_A4.book 73 ページ ２００７年１２月６日 木曜日 午前９時２３分