5 8
MAINTENANCE AND INSPECTION
Daily check/care
WARNING
・
Before starting inspection or maintenance, disconnect the power plug from the receptacle.
・
Conduct inspection and maintenance only after the oven has cooled down.
・
When you remove dirt or stains from the unit’s resin parts and the control panel, use a soft wet
cloth. Do not use benzene, thinner, cleanser or a hard brush; it will cause deformation,
qualitative deterioration and/or discoloring of the components.
M o n t h l y s e r v i c i n g
●
Exanine short crcuit breaker function.
・
Put power supply code in and test it with electricity turned on.
・
First, turn on short circuit breaker.
・
Next,press red test button on short circuit breaker by using the point of ballpoint pen
etc. If short circuit is turns off, then it is normal.
・
After executing the fixed temperature operation at the set temperature 0
℃
, set the operation
temperature of the Independent Temperature Overheating Prevention Device to 0
℃
.
・
Under normal circumstances, the heater circuit is cut off in a few seconds and the
T R O U B L E
lamp and
flashes at the same time, and the alarm buzzer sounds if the alarm
buzzer function is ON.
・
After confirming, turn off the circuit breaker once, then return the setting of the Independent
Temperature Overheating Prevention Device to the proper value. Turn the circuit breaker
back ON.
If there is any question, contact our sales representative in your vicinity or our service
o f f i c e a t o n c e .
LONG STORAGE AND DISPOSAL
When you do not use the oven for a long period of time
CAUTION
WARNING
L o n g S t o r a g e a n d D i s p o s a l
●
Disconnect the power plug from the
receptacle
When you dispose of the oven.
●
Do not leave it where children can access.
Remove the knob and hinges of the door to
disable the door locking system.
