mod. CD-X 20 LB(cod. 83515) - mod. CD 20 LB(cod. 83516)
Overdischarge protection
When the battery capacity is not enough, the tool stops automatically. In this case, remove the battery from
the tool and charge the battery.
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to the
"OFF" position when released.
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the
switch trigger. Release the switch trigger to stop.
CAUTION:
Do not look in the light or see the source
of light directly.
Pull the switch trigger to light up the lamp. The lamp keeps
on lighting while the switch trigger is being pulled. The
lamp goes out approximately 10 seconds after releasing
the switch trigger.
NOTE:
When the tool is overheated, the tool stops
automatically and the lamp starts flashing. In this case,
release the switch trigger. The lamp turns off right now.
NOTE:
Use a dry cloth to wipe the dirt off the lens of the
lamp. Be careful not to scratch the lens of lamp, or it may
lower the illumination.
CAUTION:
Always check the direction of rotation before operation.
CAUTION:
Use the reversing switch only after the tool comes to a complete stop.
Changing the
Switch action
►
1.
Switch trigger
Lighting up the front lamp
Reversing switch action
►
1.
Reversing switch lever
►
1.
Lamp
