Operation
38
possible to start the engine. The starter
can also be damaged. If the engine will
not start after 5 seconds of cranking,
return the main switch to “
” (on), wait
10 seconds, then crank the engine
again.
EMU27670
Warming up engine
EMU27702
Electric start and prime start models
1.
After starting the engine, allow it to idle
for 3 minutes to warm up. Failure to do
so will shorten engine life.
2.
Check for a steady flow of water from the
cooling water pilot hole.
CAUTION:
ECM00511
A continuous flow of water from the cool-
ing water pilot hole shows that the water
pump is pumping water through the cool-
ing passages. If water is not flowing out
of the hole at all times while the engine is
running, overheating and serious dam-
age could occur. Stop the engine and
check whether the cooling water inlet on
the lower case or the cooling water pilot
hole is blocked. Consult your Yamaha
dealer if the problem cannot be located
and corrected.
EMU27740
Shifting
WARNING
EWM00180
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
CAUTION:
ECM00220
To change the boat direction or shifting
position from forward to reverse or vice-
versa, first close the throttle so that the
engine idles (or runs at low speeds).
EMU27763
Forward (tiller handle and remote
control models)
Tiller control models
1.
Place the throttle grip in the fully closed
position.
2.
Move the gear shift lever quickly and
firmly from neutral to forward.
Remote control models
ON
START
OFF
ZMU01881
START
ON
ZMU04590
ZMU01882
✩✱✣✬✤✧✲✣ ✦✫
©
2019 Yamaha Motor Corporation, U.S.A.
Содержание Z250
Страница 80: ...Consumer information 75 2 0 1 9 Y a m a h a M o t o r C o r p o r a t i o n U S A...
Страница 82: ...Consumer information 77 2 0 1 9 Y a m a h a M o t o r C o r p o r a t i o n U S A...
Страница 83: ...Consumer information 78 2 0 1 9 Y a m a h a M o t o r C o r p o r a t i o n U S A...
