Perio
d
ic maintenance an
d
a
d
justment
7-28
7
EAU24351
Supportin
g
the motorcycle
Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other mainte-
nance requiring the motorcycle to
stand upright. Check that the motorcy-
cle is in a stable and level position be-
fore starting any maintenance. A
strong wooden box can be placed un-
der the engine for added stability.
To service the front wheel
1. Stabilize the rear of the motorcy-
cle by using a motorcycle stand
or, if an additional motorcycle
stand is not available, by placing a
jack under the frame in front of the
rear wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
a jack either under each side of the
frame in front of the rear wheel or under
each side of the swingarm.
EAU24361
Front wheel
EAU56371
To remove the front wheel
WARNING
EWA10822
To avoi
d
injury, securely support the
vehicle so there is no
d
an
g
er of it
fallin
g
over.
1. Loosen the axle nut.
2. Lift the front wheel off the ground
according to the procedure in the
previous section “Supporting the
motorcycle”.
3. Remove the axle nut and washer.
4. Pull the wheel axle out, and then
remove the wheel.
NOTICE:
Do
not apply the
b
rake after the
wheel an
d
b
rake
d
isc have
b
een
remove
d
, otherwise the
b
rake
pa
d
s will
b
e force
d
shut.
[ECA11073]
1. Washer
2. Axle nut
U1SN84E0.book Page 28 Wednesday, June 10, 2015 10:24 AM