Yamaha YZ 2019 Series, Руководство по эксплуатации для владельца

Страница: 113 / 398

CHASSIS
3-25
on page 3-21.
EAM30232
CHECKING THE REAR BRAKE PADS
1. Measure:
•
Brake pad lining thickness “a”
Out of specification

Replace as a set.
TIP
The pads worn up to the indicator “b” grooves
mean that the brake pad lining thickness limit is
reached.
2. Replace:
•
Brake pad
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the protector “1” and the pad pin
plug “2”.
b. Loosen the pad pin “3”.
c. Remove the rear wheel “4” and the brake cal-
iper “5”.
Refer to “REAR WHEEL” on page 4-7.
d. Remove the pad pin “6” and the brake pads
“7”.
e. Connect the plastic hose “8” to the bleed
screw “9” and place a container under the
end of the plastic hose.
f. Loosen the bleed screw and push the brake
caliper piston in.
WARNING
EWA19170
Do not reuse the drained brake fluid.
g. Tighten the bleed screw.
h. Install the brake pad “10” and the pad pin
“11”.
TIP
• Install the brake pads with their projections “a”
into the brake caliper recesses “b”.
• Temporarily tighten the pad pin at this point.
Brake pad lining thickness limit
1.0 mm (0.04 in)
b
a
a
1
2
Bleed screw
6 N·m (0.6 kgf·m, 4.4 lb·ft)
3
4
5
7
6
9
8
T
R
.
.