Yamaha YZ 2018 Series, Руководство по эксплуатации для владельца

Страница: 359 / 402

ELECTRICAL COMPONENTS
8-60
EASB29B348
CHECKING THE BULBS AND BULB SOCK-
ETS
1. Remove:
• Bulb
ECA
NOTICE
Be sure to hold the socket firmly when re-
moving the bulb. Never pull the lead, other-
wise it may be pulled out of the terminal in
the coupler.
TIP
Bulbs “a” is used for warning light and can be
removed form their respective socket by care-
fully pulling them out.
2. Check:
• Bulb (for continuity)
(with the digital circuit tester)
No continuity

Replace.
TIP
Before checking for continuity, set the digital
circuit tester to the “

” range.
3. Check:
• Bulb socket (for continuity)
(with the digital circuit tester)
No continuity

Replace.
TIP
Check each bulb socket for continuity in the
same manner as described in the bulb section;
however, note the following.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Install a good bulb into the bulb socket.
b. Connect the digital circuit tester probes to
the respective leads of the bulb socket.
c. Check the bulb socket for continuity. If any of
the readings indicate no continuity, replace
the bulb socket.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EASB29B349
CHECKING THE FUSES
The following procedure applies to all of the
fuses.
ECA
NOTICE
To avoid a short circuit, always stop the en-
gine when checking or replacing a fuse.
1. Remove:
• Side cover (left/right)
• Seat
Refer to “GENERAL CHASSIS” on page 4-
1.
2. Check:
• Main fuse “1”
• Radiator fan motor fuse “2”
Digital circuit tester (CD732)
90890-03243
Model 88 Multimeter with
tachometer
YU-A1927
Digital circuit tester (CD732)
90890-03243
Model 88 Multimeter with
tachometer
YU-A1927
a
1
2