Yamaha YXZ 1000R SS 2020, Руководство пользователя

Страница: 96 / 220

7-4
7
TIP

To use the drive select lever, you must be
pressing the brake pedal and be stopped
(be traveling less than 5 km/h [3 mph]), and
the engine should be at idle speed.

You can shift between forward (first gear)
and reverse gear directly - it is not neces-
sary to shift into neutral.

When using the shift paddles, YCC-S may
not complete the upshift if engine or vehicle
speed is too low, nor complete the down-
shift if engine or vehicle speed is too high.

When AUTO DOWNSHIFT is downshifting
gears, do not operate the shift paddles or
accelerator pedal.

During an emergency stop or sudden brak-
ing, AUTO DOWNSHIFT will not downshift
the transmission to first gear. Use the shift
paddle “
” to downshift, and then apply
the accelerator pedal to resume normal op-
eration.
NOTICE
ECB03370
Even with the transmission in the neutral
position, do not coast for long periods of
time with the engine off. The transmission
is properly lubricated only when the engine
is running. Inadequate lubrication may
damage the transmission.
To start out and accelerate
1. Take your foot off the accelerator pedal
and apply the brake pedal.
NOTICE:
Al-
ways take your foot off the accelerator
pedal before operating the drive select
lever, otherwise damage to the engine
and drivetrain may result.
[ECB03360]
2. Release the parking brake (if applied).
3. Shift into first gear using the drive select
lever (the transmission gear display
should show “1”).
4. Release the brake pedal and press the
accelerator pedal gradually.
UBAS11E0.book Page 4 Friday, October 23, 2020 6:02 PM