YST-RSW300
8
■
CHECKS AND ADJUSTMENTS
Devices required
Signal generator
8-ohm or 6-ohm load resistor
Oscilloscope (dual trace type)
Connection
1) Connect the output signal from the signal genera-
tor to the input terminal of the main unit.
2) Disconnect the connector terminal connected to
the speaker unit and reconnect it to the load resis-
tor.
3) Connect the HOT side of the oscilloscope CH1
probe to the point A or B indicated in the figure and
the GND side to the GND of the main unit. (Fig. 1)
4) Connect the oscilloscope CH2 input to the red side
of the connector cable, which is connected with the
load resistor.
At this time, the GND terminal of CH2 must be left
unconnected.
V: 20 V/div
H: 2 msec/div
DC range
1 : 1 probe
●
Confirmation of power amplifier operation
For the power amplifier which has been repaired, it is absolutely necessary to confirm that a correct waveform is obtained
at points indicated by A and B in the schematic diagram according to the following procedure.
Setting
1) Set the signal generator to the sine wave, 100 Hz
and minimum output level settings.
2) Set the volume of the main unit to the minimum po-
sition.
3) Turn on the power to the main unit.
4) Adjust the output level of the signal generator and
the volume of the main unit so that the output level
observed at oscilloscope CH2 is 26 Vp-p to 28 Vp-p.
Waveform observation
With the settings made as described above, observe
the waveform obtained at CH1 for judgment.
Point A (Cathode of D29/D30)
V: 20 V/div
H: 2 msec/div
DC range
1 : 1 probe
Point B (Anode of D27/D28)
●
Idling adjustment
To stabilize operation of the amplifier, turn ON the power with no input signal and wait for 2 to 3 minutes in non loaded
condition before the adjustment.
Confirm that the voltage across the terminals TP1 and TP2 is 20 mV to 350 mV.
If it exceeds 350 mV, open (cut off) R136.
Attention:
If the idling current exceeds 350 mV after a power amplifier repair, check for a defective component before cutting the
resistor.
DRIVER
WOOFER
PS
AMP
PS
AMP
POWER
DRIVE
POWER
DRIVE
PS AMP
PS AMP
A
D29
D30
D29
D30
D28
D27
D28
D27
R136
TP2
DC 20 mV to 350 mV
DC 20 mV to 350 mV
B
TP1
D30
D29
D30
GND
D29
D27
D28
D27
D28
TP2
R136
TP1
B
DC 20 mV to 350 mV
A
Fig. 1
MAIN (1) P.C.B.
26-28 Vp-p
26-28 Vp-p
Содержание YST-RSW300
Страница 3: ...YST RSW300 3 YST RSW300 REAR PANELS U C models R model K model A model ...
Страница 19: ...YST RSW300 ...