AUTO SETUP (IntelliBeam)
32
En
8
Check that the following screen is displayed
on your TV.
The results of the AUTO SETUP procedure are
displayed on your TV.
y
• If ‘‘ENVIRONMENT CHECK [FAILED]’’ is
displayed, we recommend running the AUTO SETUP
procedure again. For details, see step 9.
• If ‘‘SUBWOOFER : NOT APPLICABLE’’ is
displayed even though a subwoofer is connected to this
unit, increase the volume level of the subwoofer and
run the AUTO SETUP procedure again.
• Depending on the environment of your listening room,
the beam angle of front left and right, and surround left
and right may be set to the same value even if 5BEAM
is displayed as a result.
9
Press ENTER to confirm the results or press
RETURN to cancel the results.
The following screen is displayed temporarily for 2
seconds and then disappears from your TV.
If ‘‘ENVIRONMENT CHECK [FAILED]’’ is displayed in
step 8, the following screen is displayed after pressing
ENTER. In this case, see ERROR E-1 in “Error messages
for AUTO SETUP” on page 33. Press ENTER to exit the
AUTO SETUP and then run the procedure again from
step 3.
10
Disconnect the optimizer microphone from
the OPTIMIZER MIC jack on the front panel.
MEASUREMENT COMPLETE
BEAM MODE
:5 BEAM
SUBWOOFER :NOT APPLICABLE
[ENTER]:Save set-up.
[RETURN]:Do not save set-up.
SHOW RESULT
Example 1
MEASUREMENT COMPLETE
ENVIRONMENT CHECK[FAILED]
BEAM MODE
:5 BEAM
SUBWOOFER :YES
[ENTER]:Save set-up.
[RETURN]:Do not save set-up.
SHOW RESULT
Example 2
AUTO SETUP COMPLETE
Please remove
the MIC from
the YSP and the listening
position.
ENTER
AUTO SETUP COMPLETE
Your YSP
unit may not be set
up correctly.
We recommend you try again.
Please press [ENTER] key to
exit.
OPTIMIZER MIC
