Yamaha YHT-24, Руководство по быстрой настройке

Страница: 10 / 12

YHT-24 Q
U I C K
-C
O N N E CT
G
U I D E
10
P
ROGRAMMING
T
HE
U
NIVERSAL
R
EMOTE
C
ONTROL
S
ETTING
U
P
C
OMPONENTS
Perform the procedure for each component you own.
At the end of each step 5, the remote control’s processor
will automatically assign the selected component’s
control functions to its own buttons, ready for your use.
S
ETTING
U
P
Y
OUR
TV
1. Turn on the television set and look up a setup code
for your brand of television (codes are located at the
back of the
HTR-5440 Owner’s Manual ).
2. On the remote control, press TV.
3. Press and hold both VOLUME buttons at least four
seconds until the indicator LED flashes twice.
4. Using the keypad, enter the four-digit setup code.
The indicator LED will flash twice after your entry.
If the LED did not flash twice, repeat steps 3 and 4.
5. To verify the code works, aim the remote control at
the television set, press TV, and then press POWER.
The television set should turn off. If it doesn’t
respond, use another code for the same manufac-
turer and repeat steps 3 through 5.
The YHT-24 Home Theater package includes a univer-
sal pre-programmed remote control with factory codes
to control your HTR-5440 receiver and most Yamaha
audio components. To program other brands of compo-
nents (i.e., TV, VCR, etc.) or if your Yamaha unit does
not respond, you will need to program the remote
control with the manufacturer’s codes (listed on the
back pages of the
HTR-5440 Owner’s Manual ).
NOTE: This remote control is designed to control most major
brands of audio and video components. For other units, use
the original remote control supplied with the product.
P
OWER
O
N
1. Load the supplied batteries into the remote control.
2. Aim the remote control at the HTR-5440, press
AMP/TUNER, and then press POWER.
3. The receiver should turn on.
Indicator LED
Use Keypad
To Enter
Setup Codes
Turns On
Component’s
Power
Component
Selector
Buttons
Use To Enter
Setup Mode
Use To Enter
Setup Mode