30
YDP-163/YDP-143 Owner’s Manual
Keyboard Stand Assembly
The illustrations here are taken from the YDP-143.
CAUTION
• Be careful not to confuse parts, and be sure to install all
parts in the correct orientation. Please assemble the unit in
accordance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Assemble the unit on a hard and flat floor with ample space.
• Be sure to use the included screws only, and insert screws
of the correct size in the correct hole locations. Use of
incorrect screws can cause damage or malfunction of the
product.
• Be sure to tighten all screws upon completing assembly of
the unit.
• To disassemble, reverse the assembly sequence given
below.
Remove all parts from the package and make sure you
have all of the items.
* The adaptor may not be included, or may look different from the
illustration above, depending on your particular area. Please
check with your Yamaha dealer.
1.
After untying the bundled pedal
cord on C, attach C to D and E and
fasten the screws (1-3).
1-1
Untie and straighten out the bundled pedal
cord.
1-2
Align D and E with each end of C.
1-3
Attach D and E to C by finger-tightening
the long screws
1
(6 x 20 mm).
Have a Phillips-head (+) screwdriver of the appropriate size
ready.
E
A
B
C
D
Bundled pedal cord inside
AC adaptor
(YDP-163)
Power cord
(YDP-163)
AC adaptor
(YDP-143)
Cord holder
Screws set
1
6 x 20 mm
long screws x 4
2
6 x 16 mm
short screws x 4
3
4 x 12 mm
thin screws x 2
4
4 x 20 mm
tapping screws x 4
Headphone hanger set (YDP-163 only)
4×10 mm thin screws
Headphone hanger
D
E
C
1-3
1-2
1-1
C
Untie the two vinyl strings.
Содержание YDP143R
Страница 2: ...2 YDP 163 YDP 143 Owner s Manual ...