Yamaha XTZ7N 2021, Руководство пользователя

Страница: 50 / 112

Operation an d important ri d in g points
6-2
6
EAU90961
Startin g the en g ine
The ignition circuit cut-off system will
enable starting when:

the transmission is in the neutral
position or

the transmission is in gear, the
sidestand is up, and the clutch le-
ver is pulled.
To start the engine
1. Turn the main switch on and set
the engine stop switch to the run
position.
2. Confirm the indicator and warning
light(s) come on for a few sec-
onds, and then go off. (See page
4-2.)
TIP

Do not start the engine if the en-
gine trouble warning light remains
on.

The oil pressure warning light
should come on, go off briefly, and
then remain on until the engine is
started.

The ABS warning light should
come on and stay on until the ve-
hicle reaches a speed of 10 km/h
(6 mi/h).
3. Shift the transmission into the
neutral position.
4. Start the engine by pushing the
start switch.
5. Release the start switch when the
engine starts, or after 5 seconds.
Wait 10 seconds before pressing
the switch again to allow battery
voltage to restore.
NOTICE
ECA11043
For maximum en g ine life, never ac-
celerate har d when the en g ine is
col d !
EAUM3632
TIP
This model is equipped with:

a lean angle sensor. This sensor
stops the engine in case of a vehi-
cle turnover. If this happens, the
engine trouble warning light will
come on, but this is not a malfunc-
tion. Turn the vehicle power off
and then back on again to cancel
the warning light. Failing to do so
will prevent the engine from start-
ing even though the engine will
crank when pushing the start
switch.

an engine auto-stop system. The
engine stops automatically if left
idling for 20 minutes. If the engine
stops, simply push the start
switch to restart the engine.
UBHL10E0.book Page 2 Tuesday, October 5, 2021 9:57 AM