Instrument an
d
control functions
5-3
5
TIP
When the dimmer switch is set
to “
”, the passing switch has no ef-
fect.
EAU98390
Dimmer switch “
/
”
Set this switch to “
” for the high
beam and to “
” for the low beam.
EAU66040
Turn si
g
nal switch “
/
”
To signal a right-hand turn, push this
switch to “
”. To signal a left-hand
turn, push this switch to “
”. When
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
EAU66030
Horn switch “
”
Press this switch to sound the horn.
EAU66061
Stop/Run/Start switch “
/
/
”
To crank the engine with the starter,
set this switch to “
”, and then push
the switch down towards “
”. See
page 7-2 for starting instructions prior
to starting the engine.
Set this switch to “
” to stop the en-
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
EAUA0830
Hazar
d
switch “OFF/
”
With the main switch in the “ON” posi-
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
ECA10062
Do not use the hazar
d
li
g
hts for an
exten
d
e
d
len
g
th of time with the en-
g
ine not runnin
g
, otherwise the
b
at-
tery may
d
ischar
g
e.
EAU98024
Wheel switch “
”
This switch operates the information
display and menu system.
Operate this switch as follows:
Rotate
- rotate the wheel up-
ward/downward.
Short press
- briefly press the wheel
inward.
Lon
g
press
- press the wheel inward
for one second.
TIP
See page 5-5 for more information
on the main display screen and its
functions.
See page 5-11 for more informa-
tion on the menu system and how
to make setting changes.
UBVW70E0.book Page 3 Friday, July 21, 2023 10:52 AM
