Yamaha XP560D, Руководство пользователя

Страница: 71 / 126

Operation an d important ri d in g points
7-2
7
EAU88770
Startin g the en g ine
The ignition circuit cut-off system will
enable starting when the sidestand is
be up.
To start the engine
1. With the smart key turned on, ap-
proach the vehicle.
2. Push the “ON/ ” switch and set
the engine stop switch to the run
position.
Upon authentication of the smart
key, the beeper will sound twice
and the centerstand and steering
locks (if applied) will be released.
3. Confirm the indicator and warning
light(s) come on for a few sec-
onds, and the go off. (See page
5-2.)
TIP

Do not start the engine if the mal-
function indicator light remains on.

The ABS warning light should
come on and stay on until the ve-
hicle reaches a speed of 10 km/h
(6 mi/h).
NOTICE
ECA24110
If a warnin g or in d icator li g ht d oes
not work as d escri b e d a b ove, have a
Yamaha d ealer check the vehicle.
4. Close the throttle completely.
5. While applying the front or rear
brake, push the “ON/ ” switch.
6. Release the “ON/ ” switch when
the engine starts, or after 5 sec-
onds. Wait 10 seconds before
pressing the switch again to allow
battery voltage to restore.
NOTICE
ECA11043
For maximum en g ine life, never ac-
celerate har d when the en g ine is
col d !
EAU88780
TIP
This model is equipped with:

a lean angle sensor. This sensor
stops the engine in case of a vehi-
cle turnover. If this happens, the
malfunction indicator light will
come on, but this is not a malfunc-
tion. Turn the vehicle power off
and then back on again to cancel
the indicator light. Failing to do so
will prevent the engine from start-
ing even though the engine will
crank when pushing the start
switch.

an engine auto-stop system. The
engine stops automatically if left
idling for 20 minutes. If the engine
stops, simply push the start
switch to restart the engine.
UB3TE0E0.book Page 2 Tuesday, September 17, 2019 9:35 AM