Yamaha XMV8140, Руководство пользователя, Страница: 17 / 42

Connections and Settin g Up
XMV 8 2 8 0/XMV 8 140/XMV 8 2 8 0-D/XMV 8 140-D O w ner’s Man u al 17
1. Loosen terminal screws.
2. Insert cables.
3. Securely ti g hten terminal screws.
Pull the cables (not too strongly) to confirm that they are
securely connected.
4. Bundle the cables and the Euroblock tab
usin g the supplied cable tie.
5. Insert the Euroblock plu g into the Analo g
input connector of the device.

Making Settings for Speaker Output
Use the rear panel [SPEAKERS] DIP switches to make the
appropriate settings for the XMV’s speaker output.
The method of connection will differ depending on whether
you’re using a low impedance connection or a high imped-
ance connection.
Low-impedance connection
Hi g h-impedance connection
For details, refer to “High-impedance and Low-impedance
Connections” (page 30).
The explanation of the settings is divided into the following
sections.

When usin g low impedance connections (pa g e
17)

When usin g low impedance connections with
Double Power mode (pa g e 18)

When usin g hi g h impedance connections
(pa g e 18)
Since these settings can be made independently for channels
A/B, channels C/D, channels E/F and channels G/H, you can
use more than one of the above methods

When using low impedance connections
Depending on the impedance (4Ω or 8Ω) of the connected
speakers, set the [SPEAKERS] DIP switches as follows.
The XMV features a switch function between 8Ω and 4Ω to
guarantee the output in case it is connected to a speaker with
an impedance of 8Ω or higher.
If you connect a speaker with an impedance of 8Ω or higher,
set the [SPEAKERS] DIP switches to 8Ω. If you connect a
speaker with an impedance of 4Ω or higher, but lower than
8Ω, set the [SPEAKERS] DIP switches to 4Ω.
NOTE
A slotted scre w dri v er w ith a b lade w idth of a b o u t 3 milli-
meters is recommended.
NOTE
Trim any excess part of the ca b le tie as necessary.
Loosen.
Slotted scre w dri v er
Terminal scre w
E u ro b lock pl u g
Ta b
3 mm or less
+
–
G
Settin g
Switches 1–4
Switches 5–8
2 8 0W{140W}, 8 Ω
2 8 0W{140W}, 4Ω
NOTE
If yo u make settings for lo w impedance connections, the
HPF w ill a u tomatically b e t u rned OFF.
Total impedance(x) Settin g
4Ω x 8 Ω 4Ω
8 Ω x 8 Ω
8Ω/4Ω
10 W 10 W 10 W 10 W 10 W
70 V /100 V
Speaker transformer