Yamaha Vmax VMX12N, Дополнительное руководство по обслуживанию

Страница: 178 / 405

MIDDLE GEAR SERVICE
5. Measure:
*Starting torque (driven pinion gear)
Under specification Repeat steps from 4.
Starting Torque (Driven Pinion Gear):
0.4 0.5 Nm (0.04 0.05 kg,
0.29 0.36 Ib)
Never exceed the standard starting torque.
*Be sure to tighten the driven pinion gear nut
slowly, carefully checking measurements each
time. Exceeding the standard starting torque
may depress the collapsible collar, requiring
reassembly.
To
reassemble,
you
must replace the collapsible
collar and repeat the steps in 4 and 5
to
obtain
the standard starting torque.
6.
Position:
Yoke
7. Lubricate:
Bearings
Into
the U-joint.
Wheel Bearing Grease
8. Install:
Bearings
Onto the yoke.
Check each bearing. The needles can easily fall
out
of their races. Slide the yoke back and forth
on the bearings; the yoke will not
go
all the way
onto a bearing if a needle is out of palce.
9. Press each bearing i n t o U-joint using a
suitable socket.
NOTE:
Bearing must be inserted far enough into
joint so
that circlip can be installed.
10. Install:
Into
groove of each bearing.
3-54