Yamaha Urban Rush PW70URL, Инструкция по сборке

Страница: 12 / 18

INSTALLING THE INCLUDED PARTS
– 10 –
7
9
Check that the rear brake hose
2
, rear shift
wire
3
and speed sensor lead
9
are routed as
shown in the illustration.
10. Tightening the seat pin
Insert the saddle and seat post
1
, then tighten
the bolt
a
to the specified torque.
3
2
9
a
b
1
Tightening tor qu e 4.0 N·m (0.40 kgf·m, 3 .0 l b ·ft)
1
Saddle and seat post 1 A
8
Insert the seat post far enough that the raise
limit
b
is not visible. If installed at a posi-
tion at which the raise limit
b
is visible, the
seat post, clamp, or even frame may break,
which could cause the rider to lose control
and fall.
8
Always tighten fasteners to the correct
torque. Bolts that are too tight can stretch
and deform. Bolts that are too loose can
move and fatigue. Either mistake can lead
to a sudden failure of the bolt, causing the
rider to lose control and fall.
Do not insert the seat post completely when
lowering the saddle. The bottom edge of the
seat post could touch parts inside the seat
pipe, breaking the seat post or the parts inside
the seat pipe. If the seat post is inserted fully,
lift it slightly then fasten it.
WARNING
NOTICE