Yamaha TTR 125 2023, Руководство пользователя

Страница: 52 / 90

Perio d ic maintenance an d a d justment
7-8
7
2. Check the spark plug for electrode
erosion and excessive carbon or
other deposits, and replace it if
necessary.
3. Measure the spark plug gap with a
wire thickness gauge and, if nec-
essary, adjust the gap to specifi-
cation.
To install the spark plu g
1. Clean the surface of the spark
plug gasket and its mating sur-
face, and then wipe off any grime
from the spark plug threads.
2. Install the spark plug with the
spark plug wrench, and then tight-
en it to the specified torque.
TIP
If a torque wrench is not available
when installing a spark plug, a good
estimate of the correct torque is 1/4–
1/2 turn past finger tight. However, the
spark plug should be tightened to the
specified torque as soon as possible.
3. Install the spark plug cap.
EAUW043C
En g ine oil
The engine oil level should be checked
before each ride. In addition, the oil
must be changed at the intervals spec-
ified in the periodic maintenance and
lubrication chart.
To check the en g ine oil level
1. Place the vehicle on a level sur-
face and hold it in an upright posi-
tion. A slight tilt to the side can
result in a false reading.
2. Start the engine, warm it up for
several minutes, and then turn it
off.
3. Wait a few minutes for the oil level
to settle for an accurate reading,
remove the engine oil filler cap,
wipe the engine oil dipstick clean,
insert it back into the oil filler hole
(without screwing it in), and then
remove it again to check the oil
level.
WARNING! Never remove
the en g ine oil filler cap after
hi g h-spee d operation, other-
wise hot en g ine oil coul d spout
out an d cause d ama g e or injury.
Always let the en g ine oil cool
Specifie d spark plu g :
NGK/CR7HSA
1. Spark plug gap
Spark plu g g ap:
0.6–0.7 mm (0.024–0.028 in)
1
Ti g htenin g torque:
Spark plug:
13 N·m (1.3 kgf·m, 9.6 lb·ft)
UBSR81E0.book Page 8 Monday, April 3, 2023 10:39 AM