Yamaha TT250RA, Руководство пользователя

Страница: 51 / 88

PERIODIC MAINTENANCE AND ADJUSTMENT
7-12
2
3
4
5
6
7
8
9
for several minutes while checking
it for oil leakage. If oil is leaking, im-
mediately turn the engine off and
check for the cause.
14. Turn the engine off, and then
check the oil level and correct it if
necessary.
NOTICE
ECA16920
After replacing the engine oil, make
sure to check the oil pressure as de-
scribed below.
●
Remove the bleed bolt and its
gasket from the engine right
crankcase cover.
●
Start the engine and keep it
idling until oil flows out. If no oil
comes out after one minute,
turn the engine off immediately
so it will not seize. If this occurs,
have a Yamaha dealer repair the
vehicle.
●
Check the gasket for damage
and replace it if necessary.
●
After checking the oil pressure,
install the bleed bolt and its gas-
ket, and then tighten the bolt to
the specified torque.
EAU20904
Cleaning the air filter element
The air filter element should be cleaned
at the intervals specified in the periodic
maintenance and lubrication chart.
Clean the air filter element more fre-
quently if you are riding in unusually
wet or dusty areas.
1. Remove panel A. (See page 7-7.)
2. Loosen the fasteners by turning
them counterclockwise, and then
remove the air filter case cover to-
gether with the fasteners.
3. Pull the air filter element out of the
air filter case.
1. Bleed bolt
2. Gasket
Tightening torque:
Bleed bolt:
7 Nm (0.7 m·kgf, 5.0 ft·lbf)
1
1
2
1. Fastener
2. Air filter case cover
1
2