PERIODIC MAINTENANCE AND ADJUSTMENT
7-23
7
of the motorcycle and can lead
to chain slippage or breakage.
To prevent this from occurring,
keep the drive chain slack with-
in the specified limits.
[ECA10571]
TIP
Make sure that both adjusting plates
are in the same position for proper
wheel alignment.
4. Tighten the axle nut to the speci-
fied torque.
5. Adjust the brake pedal free play.
EAU23025
Cleaning and lubricating the
drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly wear
out, especially when riding in dusty or
wet areas. Service the drive chain as
follows.
NOTICE
ECA10583
The drive chain must be lubricated
after washing the motorcycle, riding
in the rain or riding in wet areas.
1. Clean the drive chain with kero-
sene and a small soft brush.
NOTICE:
To prevent damaging
the O-rings, do not clean the
drive chain with steam cleaners,
high-pressure washers or inap-
propriate solvents.
[ECA11121]
2. Wipe the drive chain dry.
3. Thoroughly lubricate the drive
chain with a special O-ring chain
lubricant.
NOTICE:
Do not use
engine oil or any other lubri-
cants for the drive chain, as they
1. Adjusting nut
2. Adjusting plate
3. Axle nut
Tightening torque:
Axle nut:
80 Nm (8.0 m·kgf, 58 ft·lbf)
U1C617E0.book Page 23 Wednesday, April 14, 2010 10:27 AM
Содержание TT-230RA
Страница 9: ...LOCATION OF IMPORTANT LABELS 1 2 1 U1C617E0 book Page 2 Wednesday April 14 2010 10 27 AM ...
Страница 26: ...INSTRUMENT AND CONTROL FUNCTIONS 4 10 4 U1C617E0 book Page 10 Wednesday April 14 2010 10 27 AM ...
Страница 75: ...CONSUMER INFORMATION 10 5 10 U1C617E0 book Page 5 Wednesday April 14 2010 10 27 AM ...
Страница 79: ...A5 yoko_Blank fm Page 1 Tuesday April 8 2003 11 43 AM ...