Yamaha Tenere 700 2023, Руководство пользователя

Страница: 43 / 114

Instrument an d control functions
4-25
4
5. Turn the vehicle power on, and
start the engine.
6. Turn the accessory on.
TIP
When finished riding, be sure to turn off
the accessory, disconnect it, then in-
stall the power outlet cap.
WARNING
EWA21220
To prevent electrical shock or short-
circuitin
g , make sure that the cap is
installe d when the power outlet is
not b ein g use d .
Auxiliary DC connectors
This vehicle is equipped with an auxil-
iary DC connector, a grip warmer DC
connector and a fog lamps connector.
Consult a Yamaha dealer before in-
stalling any accessories.
EAU15306
Si d estan d
The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situa-
tions. (See the following section for an
explanation of the ignition circuit cut-
off system.)
WARNING
EWA10242
The vehicle must not b e ri dd en with
the si d estan d d own, or if the si d e-
stan d cannot b e properly move d up
(or d oes not stay up), otherwise the
si d estan d coul d contact the g roun d
an d d istract the operator, resultin g
in a possi b le loss of control.
Yamaha’s i g nition circuit cut-off
system has b een d esi g ne d to assist
the operator in fulfillin g the respon-
si b ility of raisin g the si d estan d b e-
fore startin g off. Therefore, check
1. Power outlet
1
UBMB10E0.book Page 25 Monday, August 22, 2022 1:08 PM