8-15
8. Install the V-belt over the primary sheave assembly.
9. Rotate the secondary sliding sheave clockwise
6
and push
7
it so that it separates from the secondary
fixed sheave.
10. Install the V-belt
8
between the secondary sliding
and secondary fixed sheaves.
11. Install the drive guard.
WARNING
@
Never run the engine with the V-belt or drive guard
removed.
@
ESU00171
Checking the oil level of the drive chain housing
WARNING
@
The engine and muffler will be very hot after the
engine has been run. Avoid touching the engine and
muffler while they are still hot with any part of your
body or clothing during inspection or repair.
@
1. Place the snowmobile on a level surface.
2. Remove the dipstick
1
and wipe it off with a clean
rag. Then put the dipstick in the hole.
CAUTION:
@
There is a magnet attached to the end of the dipstick.
It is used to remove any metal particles that may
accumulate in the drive chain housing. When remov-
ing the dipstick be sure to:
●
Pull it out slowly and gently so the metal particles
do not fall off the magnet back into the drive
chain housing.
●
Wipe off the magnet before reinserting the dip-
stick into the drive chain housing.
@
U8EK11.book Page 15 Thursday, April 25, 2002 5:10 PM
Содержание SXV70H
