
PERIODIC MAINTENANCE AND MINOR REPAIR
6-27
6
EAU23080
To adjust the drive belt slack
1. Loosen the axle nut and the brake
caliper bracket bolt.
2. Loosen the locknut on each side of
the swingarm.
3. To tighten the drive belt, turn the
adjusting bolt on each side of the
swingarm in direction (a). To loos-
en the drive belt, turn the adjusting
bolt on each side of the swingarm
in direction (b), and then push the
rear wheel forward.
NOTE:
Using the alignment marks on each
side of the swingarm, make sure that
both belt pullers are in the same posi-
tion for proper wheel alignment.
CAUTION:
ECA10880
Improper drive belt slack will over-
load the engine. Keep the drive belt
slack within the specified range.
4. Tighten the locknuts, the axle nut
and the brake caliper bracket bolt
to the specified torques.
1. Axle nut
1. Brake caliper bracket bolt
1. Locknut
2. Drive belt slack adjusting bolt
3. Alignment marks
Tightening torques:
Locknut:
16 Nm (1.6 m·kgf, 11 ft·lbf)
Axle nut:
150 Nm (15.0 m·kgf, 110 ft·lbf)
Brake caliper bracket bolt:
30 Nm (3.0 m·kgf, 22 ft·lbf)
U5PX16E0.book Page 27 Wednesday, May 16, 2007 10:26 AM
Содержание Star XV17PCX
Страница 1: ...5PX 28199 16 XV17PCX C XV17PCMX C OWNER S MANUAL LIT 11626 21 27...
Страница 2: ...EAU10041 U5PX16E0 book Page 1 Wednesday May 16 2007 10 26 AM...
Страница 99: ...U5PX16E0 book Page 3 Wednesday May 16 2007 10 26 AM...
Страница 100: ...PRINTED IN JAPAN 2007 05 0 5 1 CR E PRINTED ON RECYCLED PAPER YAMAHA MOTOR CO LTD...