Yamaha SR125, Руководство пользователя

Страница: 39 / 78

PERIODIC MAINTENANCE AND MINOR REPAIR
6-9
6
4. Remove the filter cover screws,
drain bolt and the oil filter cover
and oil filter.
5. Clean the oil filter and strainer with
solvent. Replace if necessary.
6. Check the O-rings. If damaged, re-
place it.
7. Install the drain bolt, filter cover
screws and drain bolt. Then tight-
en to the specified torque.
NOTE:
@
Make sure the O-ring is seated proper-
ly.
@
EC000071*
CAUTION:
@
Before reinstalling the oil drain bolt,
do not forget to install the O-ring,
compression spring, and oil strainer
in position.
@
8. Fill engine with oil. Install the oil fill-
er cap and tighten.
EC000066
CAUTION:
@
●
Do not put in any chemical addi-
tives. Engine oil also lubricates
the clutch and additives could
cause clutch slippage.
●
Be sure no foreign material en-
ters the crankcase.
@
9. Start the engine and warm up for a
few minutes. While warming up,
check for oil leakage. If oil leakage
is found, stop the engine immedi-
ately and check for the cause.
10. Stop the engine and check the oil
level.
1. Filter cover screw (
×
2)
2. Engine oil drain bolt B
Tightening torque:
Drain bolt A:
43 Nm (4.3 m·kg)
Filter cover screw:
7 Nm (0.7 m·kg)
Drain bolt B:
10 Nm (1.0 m·kg)
Recommended oil:
See page 8-1.
Oil quantity:
Total amount:
1.3 L
Periodic oil change:
1.0 L
With oil filter replacement:
1.1 L
E_3mw.book Page 9 Monday, February 5, 2001 9:54 AM