14
Chapter 2—Touring the SREV1 & RC-SREV1
SREV1—Owner’s Manual
SREV1 Rear Panel
A
Cooling fan outlets
The two cooling fans expel air out through these outlets. If the airflow is restricted, the
SREV1 may overheat, so make sure these outlets are not blocked.
B
SLOTs 1 & 2
These two slots are for use with optional mini YGDAI cards, offering a variety of analog
and digital I/O options. See “I/O Options” on page 81 for more information. Slot inputs
can be freely assigned to channels. See “Assigning Inputs” on page 35 for more informa-
tion.
C
AC IN connector
This connector is used to connect the SREV1 to a suitable AC outlet by using the sup-
plied power cord. See “Connecting the Power Cord” on page 26 for more information.
D
Grounding screw
For safety reasons, it’s important that the SREV1 is grounded properly. The supplied
power cord has a three-pin plug, and if the ground terminal of the AC outlet is
grounded, then the SREV1 will be grounded sufficiently through the power cord. If the
AC outlet does not provide a suitable ground, however, a ground connection should be
made to this grounding screw. Grounding is also an effective method for eliminating
hum, interference, and other noise.
E
DIGITAL OUT (AES/EBU) connectors
These two XLR-3-32-type connectors (AES1 and AES2) transmit up to four output sig-
nals, two per connection, as AES/EBU format digital audio. Output to channel assign-
ments are fixed. See “Output Assignments” on page 9 for more information. Use only
dedicated AES/EBU connecting cables (110
Ω
).
F
DIGITAL IN (AES/EBU) connectors
These two XLR-3-31-type connectors (AES1 and AES2) receive up to four input sig-
nals, two per connection, as AES/EBU format digital audio. AES/EBU inputs can be
freely assigned to channels. See “Assigning Inputs” on page 35 for more information.
Use only dedicated AES/EBU connecting cables (110
Ω
).
AC IN
SLOT
1
SLOT
2
WORD CLOCK IN
REMOTE
2
OUT
IN
MIDI
SERIAL
1
DIGITAL (AES/EBU)
IN
OUT
3
1
2
2
3
1
1
2
1
2
2
3
1
3
1
2
5
6
J
9
8
7
3
4
2
1
1
