Zone 2
setup
on the
RX-V765
using the
Internal Power Amp
The
RX-V765
Extra Speaker Terminals
can power one set of speakers for
Zone 2
or
Presence
speakers. If the
Extra Speaker Terminals
are utilized then the
RX-V765
cannot be set for 7.1 (Surround
Back terminals.) or Bi Amp (Surround Back terminals.)
Setting
the
Extra Speaker Terminals
Note: The
RX-V765
remote control will be used to access the
Setup Menu
of receiver.
1. Press
the
Setup
button on the remote control to enter the
Setup Menu
.
2.
Setup
,
Speaker Setup
will come up on the receiver
LED
Screen
.
3. Press
the
Enter
Button on the remote control.
4. Sp
Set,
1 Auto Setup
will come up on the receiver
LED
Screen
.
5.
Arrow
down until
2 Manual Setup
comes up in the receiver
LED
Screen
.
6. Press
the
Enter
Button on the remote control.
7.
Manual Setup
,
A) Config
will come up on the receiver
LED Screen
.
8. Press
the
Enter
Button on the remote control.
9.
SP Set
,
A) Config
will come up on the receiver
LED Screen
.
10. Press the
Enter
Button on the remote control.
11.
Config, Extra………
None will come up on the receiver
LED Screen
.
12.
Use the Left/Right Arrow
buttons on the remote to change the
Extra
to:
Extra……….Zone2
.
13. Use the
Return
and
Setup
buttons on the remote to exit the
Setup Menu
.
14.
Extra Speaker
setup is complete.
To control
Zone 2
using the
RX-V765
remote the switch at the upper most left hand corner of the remote
must be set to
Zone 2
. Once the remote has been set to
Zone 2
the following commands will be
available:
1. Selecting the input source (
AV5-6, AUDIO1-2, and V-AUX
) of
Zone 2
.
2. Adjusting the volume of
Zone 2
(when a
Zone 2
speaker is connected to the
EXTRA SP
jack).
3. Tuning
into
FM
or
AM
when “
TUNER
” is selected as the input source of
Zone 2
(see page 29 of
the owner’s manual).
4. Tuning
into
XM Satellite Radio
when “
XM
” is selected as the input source of
Zone 2
(see page
31) (U.S.A. model only).
5. Tuning
into
SIRIUS Satellite Radio
when “
SIRIUS
” is selected as the input source of
Zone 2
(see page 35) (U.S.A. model only).
6. Playing back music stored on your iPod stationed in a
Yamaha iPod
universal dock (such as
YDS-10
,
YDS-11
and
YDS-12
sold separately) connected to the
DOCK
terminal.
Note: Only
Analog
signals can be sent to
Zone 2
. If you want to output the sound from
Zone 2
, connect
an external component to
AV 5-6
or
Audio 1-2
by analog connection.
Important Safety Notice:
The EXTRA SP Speaker Terminals of this unit should not be connected to a Passive Loudspeaker
Selector Box or more than one Loudspeaker per Channel. Connection to a Passive Loudspeaker
Selector Box or Multiple Speakers per channel could create an abnormally low impedance load
resulting in amplifier damage.
