CONNECTIONS
Setting up the speaker parameters automatically (YPAO)
En
39
■
Warning messages
W-1:
Out of Phase
The speakers displayed
are connected with the
opposite polarity.
Depending on the type of
speakers you are using
and the environment in
which you have them
installed, this message
may occur even if the
speakers are connected
correctly.
Depending on the type of
speakers, “W-1” may
display even if the
speakers are connected
correctly.
Check that the speaker
po (positive), and
- (negative) are correct. If
these are connected
correctly, you can use the
speakers normally even
this message appears.
W-2:
Over 24m/80ft
The speakers displayed
are separated from the
listening position by
more than 24 m, and
cannot be adjusted
correctly.
Install the speakers with
24 m of the listening
position.
W-3:
Level Error
Volume level varies
greatly for individual
channels, and cannot be
adjusted correctly.
Check that all speakers
are installed in the same
surroundings.
Check that the speaker
po (positive), and
- (negative) are correct.
We recommend the same
speakers or speakers with
as similar specifications
as possible.
Adjust the volume of the
subwoofer.
If “W-2” or “W-3” appears, you can apply measurement results,
but they will not give optimal results. We recommend that you
resolve the problem and carry out the measurement process
again.
Содержание RX-V767
Страница 119: ...APPENDIX Index En 119 Y YPAO 32 Z Zone2 Set Multi Zone 88 ...
Страница 120: ... 2010 Yamaha Corporation YC515A0 OMEN1 ...