45
En
Editing surround decoders/sound field programs
English
INTR
ODUCTION
AD
DITIONAL
INFORMA
T
ION
APPENDIX
PRE
P
ARA
T
ION
BA
S
IC
OPERA
T
ION
AD
V
ANCED
OPERA
T
ION
Rev.Level parameter adjusts the reverberation sound level.
Increasing the value of Rev.Level makes the reverbration
sound level higher, which allows you to create more echo.
2ch Stereo only
Direct
Automatically bypasses the DSP circuit and tone control
circuit when an analog sound source is selected as the
input source. This creates a higher quality sound.
y
•
See page 49 for equalizers that can be used with this unit.
7ch Stereo only
CT Level
/
SL Level
/
SR Level
/
SB Level
/
PL Level
/
PR Level
Adjusts the volume ofthe center (CT), surround L (SL),
surround R (SR), surround back (SB), presence L (PL)
and presence R (PR) channels in the 7ch Stereo program.
The available parameters differ depending on the setting
of the speakers.
Straight Enhancer/7ch Enhancer only
Effect Level
Adjusts the Compressed Music Enhancer effect level. To
reduce the effect, set this parameter to “Low.”
You can customize decoder effects by setting the
following parameters. For kinds of decoders, see page 29.
When PLIIx Music/PLII Music is selected
Panorama
Adjusts the soundscape of the front sound field. A small
value increases the soundscape and a large value narrows
it (makes the center more dominant).
Dimension
Adjusts the difference in level between the front sound
field and the surround sound field. You can adjust the
difference in level created by the software being played
back to obtain the preferred sound balance. The surround
sound gets stronger as you make the value more negative
and the front sound gets stronger as you make the value
more positive.
Center Width
Spreads the center sound toward left and right according
to your preference. Set this parameter to 0 for outputting
the center sound from the center speaker only, or to 7 for
outputting it from the front left/right speaker.
When Neo:6 Music is selected
C.Image
Adjusts the front left and right channel output relative to
the center channel to make the center channel more or less
dominant as necessary.
Parameters only usable in certain sound
field programs
Choices:
Auto
*/
Off
Auto
Outputs sound by bypassing the DSP circuit and
tone control circuit when the “Bass” and “Treble”
tone controls are both set to 0 dB.
Off
Does not bypass the circuits.
Adjustable range:
0
to
100%
Choices:
High
*/
Low
Time
Le
vel
Source sound
Rev.Level
(dB)
Rear reverberation
Decoder parameters
Choices:
Off
*/
On
Adjustable range:
-3
to
STD
* to
+3
Adjustable range:
0
to
3
* to
7
Adjustable range:
0.0
to
0.3
* to
1.0
