En
88
Setup menu items
Menu
Item
Function
Page
Speaker
Auto Setup
Optimizes the speaker settings automatically (YPAO).
Manual Setup
Power Amp Assign
Selects a speaker system.
Configuration
Front
Selects the size of the front speakers.
Center
Selects whether or not a center speaker is connected and its size.
Surround
Selects whether or not surround speakers are connected and its size.
Surround Back
Selects whether or not surround back speakers are connected and its size.
Front Presence
Selects whether or not presence speakers are connected.
Subwoofer
Selects whether or not a subwoofer is connected and its phase.
Extra Bass
Sets the speakers to produce the front channel low-frequency components.
Bass Cross Over
Sets the lower limit of low-frequency component produced from speakers of which the size is set to “Small”.
Distance
Sets the distance between each speaker and listening position.
Level
Adjusts the volume of each speaker.
Parametric EQ
PEQ Select
Selects a type of equalizer to be used.
PEQ Data Copy
Copies the parametric equalizer values acquired with “Auto Setup” to the “Manual” fields for fine adjustment.
Test Tone
Enables/disabled the test tone output.
Sound
Lipsync
Adjusts the delay between video and audio output.
Dynamic Range
Selects the dynamic range adjustment method for bitstream audio (Dolby Digital and DTS signals) playback.
Max Volume
Sets the maximum volume so that sound is not too loud.
Initial Volume
Sets the initial volume for when this receiver is turned on.
Adaptive DSP Level
Selects whether to automatically adjust the CINEMA DSP effect level in conjunction with volume adjustments.
Video
Analog to Analog Conversion
Enables/disables the video conversion between the analog video jacks.
Processing
Enables/disables the video signal processing (resolution and aspect ratio).
HDMI
HDMI Control
Enables/disables HDMI Control. You can also configure the relevant settings (ARC, TV audio input, etc).
Audio Output
Selects a device to output audio (input through HDMI jacks).
Standby Through
Select whether to output videos/audio (input through HDMI jacks) to the TV when this unit is in standby mode.
Network
IP Address
Configures the network parameters (IP address, etc).
Network Standby
Selects whether or not to turn on this unit by the command from other network devices.
MAC Address Filter
Sets the MAC address filter to limit access to this unit from other network devices.
Содержание RX-V6671
Страница 128: ... 2011 Yamaha Corporation YD458B0 OMEN1 ...