RX-V395/RDS HTR5130/RDS
RX-V395/RDS
HTR5130/RDS
■
TO SERVICE PERSONNEL
1. Critical Components Information.
Components having special characteristics are marked
and must be replaced with parts having specifications equal
to those originally installed.
2. Leakage Current Measurement (For 120V Models Only).
When service has been completed, it is imperative to verify
that all exposed conductive surfaces are properly insulated
from supply circuits.
●
Meter impedance should be equivalent to 1500 ohm shunted
by 0.15
µ
F.
●
Leakage current must not exceed 0.5mA.
●
Be sure to test for leakage with the AC plug in both
polarities.
INSULATING
TABLE
EQUIPMENT
UNDER TEST
AC LEAKAGE
TESTER OR
EQUIVALENT
WALL
OUTLET
“CAUTION”
“F701
: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME TYPE 8.0A, 125V FUSE.”
CAUTION
F701
: REPLACE WITH SAME TYPE 8.0A, 125V FUSE.
ATTENTION
F701
: UTILISER UN FUSIBLE DE RECHANGE DE MEME TYPE DE 8.0A, 125V.
A
V
WARNING: CHEMICAL CONTENT NOTICE!
The solder used in the production of this product contains LEAD. In addition, other electrical/electronic and/or
plastic (where applicable) components may also contain traces of chemicals found by the California Health and
Welfare Agency (and possibly other entities) to cause cancer and/or birth defects or other reproductive harm.
DO NOT PLACE SOLDER, ELECTRICAL/ELECTRONIC OR PLASTIC COMPONENTS IN YOUR MOUTH FOR
ANY REASON WHATSOEVER!
Avoid prolonged, unprotected contact between solder and your skin! When soldering, do not inhale solder fumes
or expose eyes to solder/flux vapor!
If you come in contact with solder or components located inside the enclosure of this product, wash your hands
before handling food.
1
IMPEDANCE SELECTOR
WARNING
Do not change the IMPEDANCE SELECTOR switch
setting while the power to this unit is on, otherwise
this unit may be damaged.
Manufactured under license from Dolby Laboratories Licens-
ing Corporation. "Dolby", "Pro Logic", and the double-D
symbol are trademarks of Dolby Laboratories Licensing
Corporation.
AC OUTLETS
100W MAX. TOTAL
SWITCHED
SPEAKERS
MAIN
A
B
+
+
–
REAR
(SURROUND)
CENTER
–
CAUTION:
SEE INSTRUCTION MANUAL FOR CORRECT SETTING
IMPEDANCE SELECTOR
SET BEFORE POWER ON
120V 60Hz
A
B
–
MAIN A OR B: 4
Ω
MIN. /SPEAKER
CENTER
REAR
A+B: 8
Ω
MIN. /SPEAKER
: 6
Ω
MIN. /SPEAKER
: 6
Ω
MIN. /SPEAKER
MAIN A OR B: 8
Ω
MIN. /SPEAKER
CENTER
REAR
A+B:16
Ω
MIN. /SPEAKER
: 8
Ω
MIN. /SPEAKER
: 8
Ω
MIN. /SPEAKER
MANUFACTURED UNDER LICENSE FROM DOLBY
LABORATORIES LICENSING CORPORATION.
"DOLBY", "PRO LOGIC" AND THE DOUBLE-D
SYMBOL ARE TRADEMARKS OF
DOLBY LABORATORIES LICENSING CORPORATION.
WARNING
:TO REDUCE THE RISK OF
FIRE OR ELECTRIC SHOCK. DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE
THIS DEVICE COMPLIES WITH PART 15 OF
THE FCC RULES. OPERATION IS SUBJECT
TO THE CONDITION THAT THIS DEVICE
DOES NOT CAUSE HARMFUL INTERFERENCE.