133
En
Troubleshooting
AD
DITIONAL
INFO
RMA
T
ION
English
During Auto Setup
After Auto Setup
• If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “Auto Setup” again.
• If warning “W2” or “W3” appears, the adjustment are made, however the adjustments may not be optimal.
• Depending on the speakers, warning “W1” may appears even if the speakers connections are correct.
• If error “E10” occurs repeatedly, please contact a qualified Yamaha service center.
Error message
Cause
Remedy
See
page
E01:No Front SP
Front L/R channel signals are not detected.
Check the front L/R speaker connections.
E02:No Sur. SP
A surround channel signal is not detected.
Check the surround speaker connections.
E03:No PRNS SP
A presence channel signal is not detected.
Check the presence speaker connections.
E04:SBR
→
SBL
Only right surround back channel signal is
detected.
Connect the surround back speaker to the
SURROUND BACK SINGLE terminal if
you only have one surround back speaker.
E05:Noisy
Background noise is too loud.
Try running “Auto Setup” in a quiet
environment.
—
Turn off noisy electric equipment like air
conditioners or move them away from the
optimizer microphone.
—
E06:Check Sur.
Surround back speakers are connected,
though surround L/R speakers are not.
Connect surround speakers when you use
surround back speakers.
E07:No MIC
The optimizer microphone was unplugged
during the “Auto Setup” procedure.
Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.
E08:No Signal
The optimizer microphone does not detect
test tones.
Check the microphone setting.
Check the speaker connections and
placement.
E09:User Cancel
The “Auto Setup” procedure was cancelled
due to user activity.
Run “Auto Setup” again.
E10:Internal Err.
An internal error occurred.
Run “Auto Setup” again.
Warning message
Cause
Remedy
See
page
W1:Out of Phase
Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
Check the speaker connections for proper
polarity (+ or –).
W2:Over Distance
The distance between the speaker and the
listening position is over 24 m (80 ft).
Bring the speaker closer to the listening
position.
—
W3:Level Error
The difference of volume level among
speakers is excessive.
Readjust the speaker installation so that all
speakers are set in locations with similar
conditions.
—
Check the speaker connections.
Use speakers of similar quality.
—
Adjust the output volume of the subwoofer.
W4:SP Mismatch
The result of the wiring check of “Auto
Setup” is different from “Speaker Set” in
“Manual Setup”.
Use “Speaker Set” in “Manual Setup” to
adjust the speaker settings manually.
Notes