60
SET MENU
N o r m a l
- 1 0 d B
1F MAIN LEVEL
N o r m a l
- 1 0 d B
1F MAIN LEVEL
2 LOW FRQ TEST
Use this feature to adjust the output level of the
subwoofer so it matches that of the other speakers in your
configuration. Change the setting with the remote control
while sitting in the listening position.
1
Press –/+ to set “TEST TONE” to ON, and
adjust the volume with /– so you
can hear the tone.
Notes
• Do not turn up the volume too high.
• If no test tone is heard, turn down the volume, set this unit in
the standby mode and make sure all the necessary connections
are correct.
2
Press
n
to go to “OUTPUT” and press –/+ to
select the speaker you want to compare with
the subwoofer.
If SWFR is selected, the test tone above 90 Hz will
not be output from the subwoofer. The test tone will
not necessarily be output from the selected speakers.
The output mode of the test tone depends on the
settings of “1 SPEAKER SET” on the SET MENU.
3
Press
n
to go to “FRQ” and press –/+ to
select the frequency you want to use.
■
1F MAIN LEVEL (main level
mode)
Change this setting if you cannot match the output level
of the center, rear (L/R) and rear center speakers with the
main speakers because of the unusually high-efficiency
performance of the main speakers.
Choices: Normal, –10 dB
Initial setting: Normal
Normal
Select this if you can match the output level of your effect
speakers with that of your main speakers when using the
test tone.
–10 dB
Select this if you cannot match the output level of your
effect speakers with that of your main speakers when
using the test tone.
2 LOW FRQ TEST
O U T P U T … M A I N
L / R
F R Q … … … … … … … … 8 8 H z
≥
T E S T
T O N E … … … … O N
2 LOW FRQ TEST
≥
O U T P U T … M A I N
L / R
F R Q … … … … … … … … 8 8 H z
T E S T
T O N E … … … O F F
2 LOW FRQ TEST
O U T P U T … M A I N
L / R
≥
F R Q … … … … … … … … 8 8 H z
T E S T
T O N E … … … O F F
