86
Appendix
The remote control does not
work.
The remote control does not
function properly.
The remote control
does not “learn” new functions.
(The TRANSMIT indicator does
not light up or flash.)
Continuous functions such as
volume are learned, but
operate only for a moment
before stopping.
Replace the batteries with new ones and
press RESET (see page 5).
Press RESET on the remote control (see
page 5).
The remote control will function within a
maximum range of 6 m (20 feet), no more
than 30 degrees off-axis from the front panel
(see page 5).
Change the position of this unit.
Press RESET on the remote control (see
page 5).
Replace the batteries (and press RESET on
the remote control) (see page 5).
Place the remote controls at the proper
distance (see page 62).
Learning is not possible.
Further learning is not possible without
deleting unnecessary new functions (see
page 66).
Press RESET on the remote control (see
page 5).
Be sure to press and hold the function button
on the other remote control until TRANSMIT
begins flashing slowly.
The batteries are dead.
The internal microcomputer has “frozen”.
Wrong distance or angle.
Direct sunlight or lighting (such as an
inverter type of fluorescent lamp) is
striking the remote control sensor of this
unit.
The internal microcomputer has “frozen”.
The batteries of this remote control and/or
the other remote control are too weak.
The distance between the two remote
controls is too far or near.
The signal coding or modulation of the
other remote control is not compatible with
this remote control.
Memory capacity is full.
The internal microcomputer has “frozen”.
The learning process is incomplete.
Problem
Possible Cause
What to Do
Remote Control
Troubleshooting
