Yamaha RP-U100, Руководство пользователя

Страница: 5 / 97

v
Read the Following Before Operating the Unit
1. To ensure the finest performance, please
read this manual carefully. Keep it in a safe
place for future reference.
2. Install this unit in a cool, dry, clean place –
away from windows, heat sources, sources of
excessive vibration, dust, moisture and cold.
Avoid sources of hum (transformers, motors).
To prevent fire or electrical shock, do not
expose the unit to rain or water.
3. Never open the cabinet. If something drops
into the unit, contact your dealer.
4. Do not use force with switches, controls or
connection wires. When moving the unit, first
disconnect the power plug and the wires
connected to other equipment. Never pull the
wires.
5. Do not touch the top cover, since it may
become hot after extended high-power
operation. This cover has openings for proper
ventilation of the unit. Do not place any
objects on these openings. If the openings
are obstructed, the temperature inside the
unit will rise rapidly. Also, be sure to install the
unit vertically, not horizontally, in a well-
ventilated area and allow enough clearance
from the surrounding objects. Otherwise the
receiver may be damaged or a fire may be
caused.
6. The voltage used must be the same as that
specified on this unit. Using this unit with a
higher voltage than specified is dangerous
and may result in fire or other accidents.
YAMAHA will not be held responsible for any
damage resulting from use of this unit with a
voltage other than specified.
7. Digital signals generated by this unit may
interfere with other equipment such as tuners,
receivers, or TVs. Move this unit farther away
from such equipment if interference is
observed.
8. Always set the volume control to minimum
before starting audio playback. Increase the
volume gradually to an appropriate level after
playback has been started.
9. Do not attempt to clean the unit with chemical
solvents; this might damage the finish. Use a
clean, dry cloth.
10. Be sure to read the “Troubleshooting” section
regarding common operating errors before
concluding that the unit is faulty.
11. When not planning to use this unit for long
periods of time (i.e., vacation, etc.),
disconnect the AC power plug from the wall
outlet.
12. To prevent lightning damage, disconnect the
AC power plug and disconnect the antenna
cable when there is an electrical storm.
This unit is not fully disconnected from the AC
power source as long as it is connected to the
wall outlet, even if this unit itself is turned off.
This state is called “standby mode.”
In this mode, the unit consumes a small amount
of electricity.