Yamaha R-S700BL, Руководство пользователя

Страница: 17 / 71

13
En
CONNECTIONS
PREP
ARA
TION
■
IMPEDANCE SELECTOR switch
Do not change the IMPEDANCE SELECTOR switch
while the power of this unit is turned on, as doing so may
damage the unit.
If the unit fails to turn on, the IMPEDANCE SELECTOR
switch may not be fully slid to either position. If this is the
case, remove the power cable and slide the switch all the
way to either position.
Select the switch position (LOW or HIGH) according to
the impedance of the speakers in your system.
■
Connecting speaker cables
When inserting speaker cables into the speaker terminals, insert
only the bare speaker wire. If insulated cable is inserted, the
connection may be poor and sound may not be heard.
■
Connecting via banana plug
Tighten the knob and then insert the banana plug into the
end of the corresponding terminal.
■
Bi-wire connection
Bi-wire connection separates the woofer from the
combined midrange and tweeter section. A bi-wire
compatible speaker has four binding post terminals. These
two sets of terminals allow the speaker to be split into two
independent sections. With these connections, the mid and
high frequency drivers are connected to one set of
terminals and the low frequency driver to another set of
terminals.
Connect the other speaker to the other set of terminals in
the same way.
When making bi-wire connections, set the IMPEDANCE
SELECTOR switch to HIGH or LOW depending on the
impedance of your speakers:
6
Ω or higher: HIGH (R-S700)
8
Ω
or higher: HIGH (R-S500)
4 Ω or higher: LOW
See page 13 for more information about the
IMPEDANCE SELECTOR switch.
When making bi-wire connections, remove the shorting bridges
or cables on the speaker.
y
To use the bi-wire connections, press SPEAKERS A and
SPEAKERS B on the front panel or on the remote control so that
both SP A and B light up on the front panel display.
CAUTION
Switch
position
Impedance level
HIGH
• If you use one set (A or B), the impedance of
each speaker must be 6 Ω or higher (R-S700)
or 8 Ω or higher (R-S500).
• If you make bi-wire connections, the
impedance of each speaker must be 6 Ω or
higher (R-S700) or 8 Ω or higher (R-S500).
See page 13 for Bi-wire connection.
LOW
• If you use one set (A or B), the impedance of
each speaker must be 4 Ω or higher.
• If you use two sets (A and B) simultaneously,
the impedance of each speaker must be 8 Ω or
higher.
• If you make bi-wire connections, the
impedance of each speaker must be 4 Ω or
higher. See page 13 for Bi-wire connection.
Note
Remove
approximately
10 mm (3/8 in)
of insulation
from the end of
each speaker
cable.
Banana plug
CAUTION
Note
This unit
Speaker
SPEAKERS A/B
SPEAKERS A/B